Furnace replacement cost in Boston, MA (2026)
| Condensing gas furnace, 60–80k BTU, single-stage | $2,565 – $4,050 |
| Labor, one day for 1–2 technicians, including startup | $1,620 – $2,565 |
| PVC intake/exhaust run, condensate drain or pump, gas and electrical reconnection, thermostat | $810 – $1,485 |
| Permit, inspection, haul-away | $405 – $675 |
Estimate, not survey data. These Boston figures are the national planning estimate adjusted by the highest-cost metro regional multiplier (1.35×). Actual quotes will vary. Try the interactive calculator →
Boston homeowners can expect to pay $5,400 to $8,775 for a typical furnace replacement project in 2026, 35% above the national average. Highest-tier labor costs in the country. Massachusetts stretch energy code pushes toward high-efficiency equipment. Old housing stock (many pre-1920 homes) frequently requires code-upgrade work during replacements.
Why furnace replacement costs differ in Boston
Boston falls into the highest-cost metro tier for home repair costs — nyc, sf bay area, la, seattle, boston, dc, hawaii, alaska. Several local factors drive this:
- •Highest-tier labor market in the U.S.
- •Massachusetts stretch energy code mandates
- •Old housing stock often needs code upgrades during replacements
- •Short exterior-work season compresses scheduling
Boston climate and scheduling
Cold winters with heavy snow loads stress roofing. Nor'easters drive emergency repair demand spikes.
May through October for exterior work. The short working season compresses demand, so book early. Furnace work is best in September and October.
Furnace replacement permits in Boston
Residential permit fees in Boston, MA typically run $100–$500 for this type of work. Boston ISD handles permits. Massachusetts requires contractor licensing for most trades. Energy code (stretch code) adds insulation and efficiency requirements beyond base IRC.
Your contractor should pull the permit and build the fee into their quote. If they suggest skipping the permit, that's a red flag — unpermitted work can create problems with insurance claims, home sales, and code compliance.
Signs it's time to replace in Boston
Cold winters with heavy snow loads stress roofing. Nor'easters drive emergency repair demand spikes. Watch for these signs:
- ⚠The furnace is 15–20+ years old and needs a repair costing more than about a third of a new unit
- ⚠A cracked heat exchanger — a safety condition, and effectively the end of the furnace
- ⚠Frequent breakdowns, short cycling, or a blower or control board failure on an old unit
- ⚠Yellow or flickering burner flames, soot, or a CO alarm event (shut it down and call a pro)
- ⚠Rising gas bills and uneven heat despite a clean filter and sealed ducts
Get a more specific estimate
The figures above are for a typical job in Boston. Your project may differ based on system size, materials, access, and condition. Use our interactive calculator to adjust the inputs for your specific situation.
Open the furnace replacement calculator →Other home repair costs in Boston
Furnace replacement cost in other cities
Where these numbers come from
National figures come from the sources below. Boston figures apply the highest-cost metro regional multiplier (1.35×) to account for local labor rates and cost of living.
| Source | Published figure | Basis |
|---|---|---|
| Carrier — Gas Furnace Replacement Guide | Installed cost of a new furnace typically $3,800–$12,000 in 2026 | Manufacturer guidance |
| HVACBase — Furnace Installation Cost (2026) | Gas furnace $3,500–$8,500 installed, national average $5,500 | Editorial estimate |
| Inch Calculator — Cost to Install a Furnace | $5,000–$7,500 for a 2,000 sq ft home reusing existing ductwork, average about $6,250 | Editorial estimate |
Last updated November 2026. Figures are planning estimates, not quotes. Methodology · Disclosure