Skip to content

Furnace replacement cost in Minneapolis–St. Paul, MN (2026)

Minneapolis–St. Paul installed price (planning estimate)
$4,600 – $7,475
Midpoint about $6,000 · 15% above the national average
Do it yourself?
Pro only
Licensed trade and permit work
Permits
$75–$300
Typical Minneapolis–St. Paul residential permit
Where a typical Minneapolis–St. Paul pro price goes
Condensing gas furnace, 60–80k BTU, single-stage$2,185 – $3,450
Labor, one day for 1–2 technicians, including startup$1,380 – $2,185
PVC intake/exhaust run, condensate drain or pump, gas and electrical reconnection, thermostat$690 – $1,265
Permit, inspection, haul-away$345 – $575

Estimate, not survey data. These Minneapolis–St. Paul figures are the national planning estimate adjusted by the higher-cost metro regional multiplier (1.15×). Actual quotes will vary. Try the interactive calculator →

Minneapolis–St. Paul homeowners can expect to pay $4,600 to $7,475 for a typical furnace replacement project in 2026, 15% above the national average. Extreme cold drives the highest furnace demand per capita of any major metro. Ice dams from poor attic insulation cause recurring roof damage. Many homes have both sump pumps and radon mitigation systems.

Why furnace replacement costs differ in Minneapolis–St. Paul

Minneapolis–St. Paul falls into the higher-cost metro tier for home repair costs — large metros: chicago, denver, atlanta, phoenix, minneapolis, portland. Several local factors drive this:

  • •Extreme cold requires high-efficiency furnaces (95%+ AFUE)
  • •Ice dam prevention adds to roofing costs
  • •Short exterior work season (May–September)
  • •Frozen ground delays any excavation work

Minneapolis–St. Paul climate and scheduling

Climate
Humid continental (severe) — summer highs around 83°F, winter lows around 6°F.

Among the coldest major metros in the U.S. Furnaces run 5+ months per year. Ice dams are a major roofing concern.

Best time to schedule

May through September for exterior work. The working season is even shorter than Boston. Furnace replacement should be completed by October — emergency replacements in January are expensive and scarce.

Furnace replacement permits in Minneapolis–St. Paul

Residential permit fees in Minneapolis–St. Paul, MN typically run $75–$300 for this type of work. Minneapolis and St. Paul have separate building departments. Minnesota requires contractor licensing. Energy code emphasizes high-efficiency heating equipment.

Your contractor should pull the permit and build the fee into their quote. If they suggest skipping the permit, that's a red flag — unpermitted work can create problems with insurance claims, home sales, and code compliance.

Signs it's time to replace in Minneapolis–St. Paul

Among the coldest major metros in the U.S. Furnaces run 5+ months per year. Ice dams are a major roofing concern. Watch for these signs:

  • ⚠The furnace is 15–20+ years old and needs a repair costing more than about a third of a new unit
  • ⚠A cracked heat exchanger — a safety condition, and effectively the end of the furnace
  • ⚠Frequent breakdowns, short cycling, or a blower or control board failure on an old unit
  • ⚠Yellow or flickering burner flames, soot, or a CO alarm event (shut it down and call a pro)
  • ⚠Rising gas bills and uneven heat despite a clean filter and sealed ducts

Get a more specific estimate

The figures above are for a typical job in Minneapolis–St. Paul. Your project may differ based on system size, materials, access, and condition. Use our interactive calculator to adjust the inputs for your specific situation.

Open the furnace replacement calculator →

Other home repair costs in Minneapolis–St. Paul

Furnace replacement cost in other cities

See all cities →

Where these numbers come from

National figures come from the sources below. Minneapolis–St. Paul figures apply the higher-cost metro regional multiplier (1.15×) to account for local labor rates and cost of living.

SourcePublished figureBasis
Carrier — Gas Furnace Replacement GuideInstalled cost of a new furnace typically $3,800–$12,000 in 2026Manufacturer guidance
HVACBase — Furnace Installation Cost (2026)Gas furnace $3,500–$8,500 installed, national average $5,500Editorial estimate
Inch Calculator — Cost to Install a Furnace$5,000–$7,500 for a 2,000 sq ft home reusing existing ductwork, average about $6,250Editorial estimate

Last updated November 2026. Figures are planning estimates, not quotes. Methodology · Disclosure